The Seneca Woodworking Imperial Thickness Set for the Festool Domino DF700 allows you to quickly and effortlessly adjust the Domino fence offset to center your mortise on a range of imperial material thicknesses from 1/2" to 1".  The set consists of two components:  an Imperial Thickness Gauge and a "Domi-Shim™." The Imperial Thickness Gauge installs in less than a minute using a Torx T10 bit (not included), and is a direct replacement for the metric thickness gauge included with your Domino DF700.  The Domi-Shim™ attaches to the DF700 Fence to enable centering on narrower material than was previously possible without a shim or spacer. 

The Imperial Thickness Gauge is CNC machined from Delrin material and designed to center on 1/2", 5/8", 3/4", 7/8", and 1" nominal ply thicknesses.

The Domino DF700 fence has a lower travel limit that would normally prevent it from centering on 3/4" or smaller ply so a shim is required to enable centering on these thicknesses.  This set includes the Seneca Woodworking Domi-Shim™ required to work properly.  This Domi-Shim™ can be installed by itself (without the Imperial Thickness Gauge) and used to center on 1/2" nominal ply.  This Domi-Shim™ is the same 1/2" shim we originally sold as part of our Domi-Shim™ set.  If you already own the set of two Domi-Shims, and want to upgrade to the faster adjustment that this set provides,  you can purchase the Imperial Thickness Gauge separately.

UPC CODE:850212005115

SUPPLIER PART#SWD7IG04-S